Description
Include：1x ESP-01S Relay 1x ESP-01S Module ESP-01S Relay 1.Description This ESP-01S Relay based on AI-Thinker ESP-01S WIFI module. It is designed for smart home, Internet of thing and others DIY project. With this smart relay, you will easy to DIY your smart switch to control any device by your phone anywhere. We support the APP and LUA source code. We had upload a demo code in the ESP0-01S, just supply a DC5V power, then you can control it. In the version, we use the GPIO0 of ESP-01S to control the Relay by Hight level 2.Parameter *Working voltage: DC5V *Working current: ≥250mA *Communication: ESP-01S WIFI module *Transmission distance: the maximum transmission distance of 400m (open environment, mobile phone equipped with WIFI module) *Load: 10A/250VAC 10A/30VDC, the relay pulls 100,000 times *GPIO0 of ESP-01S Control the Relay (High level active) *Product size: 37 * 25mm 3.Usage (1)Hardware connection Just plug the ESP-01S to the 2*4 pin header after download the code to ESP-01S. Show as below: (2)Power supply Connect a DC 5V power to the GND and VCC. (3)Open your phone WLAN then connect the WiFi ESP8266-XXXX, Power word:12345678 (4)Open the ESP8266 Controller.app ( Installed it in your android phone before) (5)Set IP Address: 192.168.1.1 than you can control your device via the wifi relay module E SP-01S ESP8266 Serial Module Features: Support 802.11 b/g/n standard, Wi-Fi direct (P2P), soft-AP. Integrated TCP/IP protocol stack. Integrated TR switch, balun, LNA, power amplifier and matching network. Integrated PLLs, regulators, DCXO and power management units. +19.5dBm output power in 802.11b mode. Power down leakage current of Integrated low power 32-bit CPU could be used as application processor, 1MB flash memory. SDIO 1.1 / 2.0, SPI, UART, STBC, 1×1 MIMO, 2×1 MIMO. A-MPDU & A-MSDU aggregation & 0.4ms guard interval. Wake up and transmit packets Standby power consumption Specifications: Wireless standard:802.11b/g/n Frequency range: 2.4GHz-2.5GHz(2400MHz-2483.5MHz) Data interface: UART/HSPI/I2C/I2S/IR remote control/GPIO/PWM Operating voltage: 3.0-3.6V(recommended 3.3V) Operating current: average 80mA Operating temperature:-40~125℃ Wireless network mode: station/softAP/SoftAP+station Safety mode: WPA/WPA2 Encryption type: WEP/TKIP/AES Network protocol: IPV4/TCP/UDP/HTTP/FTP Package included: 1 x ESP-01S ESP8266 Serial Module Instructions/schematic are NOT included. We don't provide technical assistance please make sure that you are familiar with the product before purchasing. On May 5, 2022 at 07:16:29 PDT, seller added the following information:
